Moonlight Systems
Delivering Powerful Handheld Solutions
Press Room
Presenter-To-Go
Display-To-Go
Video Capture
DVD Products
Quick Reference
Products Where To Buy Support About Us Press Room
You're not limited to PowerPoint anymore.
Troubleshooting
Register
Installation
FAQs
Compatibility
Downloads
Specifications
Documentation

 


Driver Installation for 1394-to-Go

WDM-based for Windows 98/98-SE

  1. Ensure to have the Windows 98/98-SE (Second Edition) CD-ROM disc inside the drive.
  2. Insert the 1394-to-Go card into a CarbBus PCMCIA slot. Recommend to use the TOP slot if two PC cards are inserted.
  3. Follow the on-screen instructions. The drivers are part of the Windows 98/98-SE Release.
  4. Confirm that the 1394-to-Go card is properly installed by running the System Properties from the Control Panel. The card should be recognized as "NEC Firewarden OHCI Compliant IEEE 1394 Host Controller" under "1394 Bus Controller" from the Device Manager.

  Configuring DV (Digital Video) Camcorder

  1. Ensure to have the Windows 98/98-SE (Second Edition) CD-ROM disc inside the drive.
  2. Plug in your DV camcorder through the i.Link cable.
  3. Follow the on-screen instructions. The drivers for the DV camcorder are part of Windows 98-SE Release.
  4. Confirm that the DV camcorder is properly configured by running the System Properties from the Control Panel. It should be recognized as "Microsoft DV Camcera and VCR" under "Imaging Device" from the Device Manager.
  Installing MARGI Total Capture application
  1. Insert the Total Capture driver CD-ROM disc into the drive, run the SETUP.EXE.
  2. Follow the on-screen instructions to complete the installation.

WDM-based for Windows 2000

  1. Ensure to have the Windows 2000 CD-ROM disc inside the drive.
  2. Insert the 1394-to-Go card into a CarbBus PCMCIA slot. Recommend to use the TOP slot if two PC cards are inserted.
  3. Follow the on-screen instructions. The drivers are part of the Windows 2000 Release.
  4. Confirm that the 1394-to-Go card is properly installed by running the System Properties from the Control Panel. The card should be recognized as "NEC Firewarden OHCI Compliant IEEE 1394 Host Controller" under "IEEE 1394 Bus Host Controller" from the Device Manager.
  Configuring DV (Digital Video) Camcorder
  1. Ensure to have the Windows 2000 CD-ROM disc inside the drive.
  2. Plug in your DV camcorder through the i.Link cable.
  3. Follow the on-screen instructions. The drivers for the DV camcorder are part of Windows 2000 Release.
  4. Confirm that the DV camcorder is properly configured by running the System Properties from the Control Panel. It should be recognized as "Microsoft DV Camcera and VCR" under "Imaging Device" from the Device Manager.

  Installing MARGI Total Capture application

  1. Insert the Total Capture driver CD-ROM disc into the drive, run the SETUP.EXE.
  2. Follow the on-screen instructions to complete the installation.
contact us   site map   policies   privacy   terms of use